Tuesday, September 17, 2019

Sponsor Spotlight: AquaSafe Installations

The Express Water 10 Stage reverse osmosis filtering system is a small and efficient system which easily fits into any kitchen cabinet. 

In the following article, we review the pros and cons of using this filtration system, and we take a closer look at its efficiency, filters, and installation.

The 10-stage filtration might seem like a lot, comparing them with the products developed by the competition, which usually provides only a 5, 6, or rarely 7-step filtration. This happens because Express Water counts every stage of the mineralization as a separate stage of the filtration process itself.

One of the advantages of using this RO system is that the water produced has a great taste. Even though the number of filters noted by Express Water’s competitors is mostly marketing, we cannot deny that the mineralized water tastes great.

Another advantage is that this filtration system comes with a nice looking faucet. The faucet is capable of delivering a water flow rate of 0.8 GPM, and it’s really nice looking.

Efficiency
The Express Water system is very efficient. Some people might find it hard to believe that a filtration system that wastes 2 gallons of water for every gallon of pure water it produces like this one is efficient, but there are reverse osmosis systems that can use up to 20 gallons of water for every filtered gallon.

When an RO system uses 4 gallons of wastewater for a gallon of pure water, it’s considered efficient. With a wastewater pure water ratio of 2:1, this unit is very efficient, ranking among the best units available on the market.

Filters
As with every reverse osmosis system, filters are very important. This system has a 10-step filtration sequence. The first 5 steps of the filtration process are exactly the same as you can find when using other models available on the market, but things change at the sixth step. 

Most manufacturers count the remineralization of the water as a single step in the filtration process, but Express Water does not. Instead, they count every step in the remineralization as a separate step in the whole process, thus the increased number of total steps.

The filtering steps are as follows – 1st step is sediment removal. This is where the larger and finer particles in the water are removed. Sand, rust, dirt and other components are blocked from going farther.
    
      
The second filter removes organic compounds, chlorine, odor, and tastes from the water. The third one further removes any tastes and odors, but it will also remove common chemicals and volatile compounds. The fourth stage is actually the reverse osmosis membrane which will stop any particles larger than 0.0001 microns, including chemicals and bacteria. The fifth stage will make the water more alkaline, improving its taste. The sixth step is separated into 4 different smaller steps, but its role is to remineralize the water.

The filters are easy to install and change. They are color-coded, so you will always be aware of which one goes where, which is especially important since there are a lot of them.

For Installation
Contact AquaSafe Installations at (516) 693-8355
or email AquaSafeInstallations@gmail.com
We do Installation and Maintenance of this Made in USA filter!
    

Pros
• Designed to easily fit under your kitchen sink.
• Great Taste – One thing is for certain, the water produced has a great taste, and nobody can deny that.
• Nice Looking Faucet – This system comes with a nice looking faucet which will make an excellent addition to most kitchens.
  
Cons
• None

No comments:

Post a Comment